i got this unit from panda
http://forums.maxima.org/showpost.ph...2&postcount=39


i got the remote start working, but if you start it and get in put the key to on and drive off, then when you get out it wont cut off, i hooked up the brake wire but it dosent cut it off, isent it sopposed to??? and something else must be wrong cuz if you dont even use the rs and use the key it wont cut off till you completly turn the key off.


the power locks isent working good, i found 3 wires that controle it i labled them 1 2 3 , if you connect 1+3 it unlocks and 2+3 it locks

but with those wired the drivers door dosent lock or unlocks, i think its just broke

the alarm has unlock no com nc, lock no com nc idk which is witch, common is 3 i guess, but what are the other, i got them to work so i put it all back to gether now its not working and the switch on the door dosent work eather.

also this alarm is def a knock off cheep o, its annoying , when you go out of range with the remote it beeps 1 every minute

i installed a rs in my maxima and i love it, but this one is going in my gf car and its not working to good, i need to get it right asap

 

Return it and get a DEI.

 

+1, definately good advice there..

 

i doubt he will take it back


DEI ???

 

It doesnt work out of the box and he wouldnt take it back? Doesnt sound like very good CS if you ask me.

DEI = Directed Electronics..www.directed.com offering Viper/Clifford/Python/Avital/etc..

 

what is avital?

 

Directed's low end DIY line.

 

yea avital isnt really that bad though. I was getting them for about 50 $ dealer price when i needed to install them at my job. Nothing fancy but good quality products from dei.

 

No, that would be BOA.

 

ima see if he will take it back



ill prob just put the other TDS pos alarm that was there