All My Friends Drive a Low Rider (largish)
#1
Well, here she is with the newly installed clearcorners (thanks courtesy nissan!) and cattman coilovers. She is looooooowwwwww. I haven't decided if I'm going to raise it up a little or not, I kinda like the look now, and it took us forever to get it level so I'm not eager to mess with it... Sorry, the lighting wasn't too great this morning...
<img src="http://www.math.ohio-state.edu/~ccunning/max-009.jpg">
<img src="http://www.math.ohio-state.edu/~ccunning/max-009.jpg">
#4
Heya Eman
Let me ask you, how did you tighten the nuts on top of the strut/shock assembly? When I first drove off there was a horrible clunking sound, and we realized that we didn't tighten down those nuts on the front. The problem we ran into is that on both the front and rear, tightening the nuts just caused the piston to spin inside the shock. So I couldn't get it very tight at all on the front. On the rear I used some vice grips to grab the top above the nut but on the front there aren't any of those. I still here a very muted clunk from the left front when I hit bumps, so I think it needs tightened more but I don't have the slightest clue how to do it...
Thread
Thread Starter
Forum
Replies
Last Post