yes the runs will be on saturday.

right now they only are definetly for 2k2's but they may fit 2k's and 2k1's i need to find one to look at.

emax, ya i noticed it's a little close. i'm gonna move it about .5 inches back. this is a proto type you know and tank u i will keep up the work. if i can get use of a mandrel bender exhaust's are coming.

 

lookin good steve, are you gonna come visit my skool again with the 2k2?? i ain't stock anymore

 

I say that once someone install one that they should do the ghetto rig of a 3-4" in diamter tube from underneath the splash guard that points right at the intake.

Looking forward to your dyno runs!

 

That filter element you are using, I have the exact same one!

 

i am doing that this week but i will be having that as an upgrade to the kit. a heatshield with ventilation. once i design it i will have pricing. i might make it out of PVC piping. we'll see how it goes. you could just use dryer tubing but that's not professional.

 

Are you going to keep the hood up during the run? I think almost all runs are with the hood up, but with it down it would be more realistic.

Also, are you going to have a fan blowing on the engine? This would be better cause it would simulate moving air, as in the case of when you're driving.

Just curious.

 

ya like any normal run. hood up and fan blowing. i think seeing as the car is stationary and in 4th it would be over 100mph. no fan can move that much air.