Hi Guys...

I got the hole drilled and everything popped the tube in the whole. Just as I thought I had got it in properly, I could line up the battery tray nor the fuse box. I used the template from
The Max Anyone have any ideas?

 

everything should just fall back into place...are you sure the hole is correctly drilled...i don't mean to question you but people have emailed me with the same problem and the hole was incorrectly drilled...

 

This ia a white cover on the bottom of the fuse box. YOu need to remove that thing and then the fuse box will fit. I don't think I had any troubles with my battery tray not going back in place. Just make sure to remove the bottom cover of the fuse box and you should be all set! Good luck!

 

Using the template.. You align the hole to the top hole from the battery tray hole right?

 

the only thing that didnt fit was the white cover at the bottom of the fuse box.......
but after removing the white cover, i noticed all the wires hanging... and i didnt like that, i just didnt think it was safe, so i cut the white plastic at an angle so that it would cover the wires and fit the pipe
for those that still have the white cover, i reccomend that....

 

what did you use too cut the hole out and was it a clean cut or kind of rough???

 

I used a 3" Dremmel tool. It's pretty much a perfect circle. The battery tray cannot line up with the holes because the pipe is in the way. Unless I need to drill the hole more to the right?