I installed the k&n intake and followed the instructions exactly and then reconnected the battery and engine fired up normally and I put it in reverse and it wouldn't let me shift it back into Park or drive!?! I then took off the shift lock to see if I could get it into Park and no luck. I just disconnected the battery and hope it's will reset itself. How the heck am I supposed to get this car back into gear?? Any suggestions?

 

You have to cut a piece of the guard by the shifts cable the intake is made for 2012 i did that on my

 

Here is a picture

 

You see the part i have to cut if you want to add the stillen pulley let me know so i can give you the belt you going to need stillen dont have not try it on 2016 yet but i did that belt is hard to found so make sure you have before you donthe pulley

 

So you couldn't shift it to drive either when you didn't cut the guard?

 

Yes you have to cut it remember this intake is not for 2016 that is the only thing you have to do to make it fit it will make a big difference and sounds good