I sent my 370's off to RC engineering to have them cleaned/new caps and o-rings put in before the install. When I got them back they came with a sheet to show how each one tested before and after the service. The average flow was 410cc, some a little more some a little less. In there comment field they put that this was "excellent" for these injectors. My question is, is this common for the 370's to flow like this? I was under the impression that 370cc would be the highest point they would reach. These injectors are out of a 95 TT Z. Thanks.

Carson

 

it probably depends on the pressure they were tested at. if i remember correctly most flow rates are rated at 43 psi and if they had the pressure higher than that it would flow higher than 370. i could be wrong though but i'm pretty sure that's what i read somewhere.

 

mine were done at rc and they flowed 350 to 365

 

mine were done at rc and they were ~405

95zTT .. green color