Either I lost my book or my GF threw it away but I need to set the Hi throttle and Lo throttle,Th- point,Dec air and sensor type. I have the whole thing hooked up by using the pinout readings and did the initial settings and such just want to get these all done correctly. I have 370cc injectors and the stock MAF just running 4psi for now. Slowly going to work my way up to 10-14 or should I just set it all for the higher boost? Any help from the Vg guys.

thanks for that but still need to find sensor type and such.

I used to have 'em on PDF. Damnit.

HW is your sensor type.

I have it set for 6 cylinder, arrow up, hot wire what should I put for in and out. low throttle 25% high throttle 48% 01,01 on the MAF. that ok to go with or should I make some adjustments.

I'd say. As long as the MAF is the same number, assuming you have the stock MAF.

yes have the stock MAF. For the in and out on the hot wire I've seen that most have 4 in and 4 out but that is not for the vg is it the same?

1/1, 2/2, 3/3 etc. As long as they're the same you're fine.

wrong thread to post in looks like you need to do some research and learn alot.... use the search on supercharger setups.

you could find the PDF here at this site. good luck


http://www.jrponline.com/downloads/docs.asp