Progress on a V1 install .........
#1
Supporting Maxima.org Member
Thread Starter
iTrader: (38)
Join Date: Dec 2000
Location: Near Archer High School, Ga
Posts: 6,451
Progress on a V1 install .........
After 5 months and putting together an incomplete V1 kit . I have installed
370ccs, MEVI, Emanage w/inject harness, Walbro fuel P, Cold air intake, rear main seal, front and rear engine seals, crank seal, lower oil pan reseal, Z32 MAF, oil feed, oil return plate, full cattman exhaust, alloy flywheel with 6 puck clutch, all left are the gauges, vacuum lines, a front charge pipe with BOV, and dyno tune. Just have to load that Greddy program to my laptop and we should see what will this little car put down.
Maxima is not my maxima. Is brians maxima, he should be back from Afghanistan this Thurs. Ill post photos later. Total time in labor about a week. Due to stuff being missing and heading to the store a bunch of times.
Jaime
370ccs, MEVI, Emanage w/inject harness, Walbro fuel P, Cold air intake, rear main seal, front and rear engine seals, crank seal, lower oil pan reseal, Z32 MAF, oil feed, oil return plate, full cattman exhaust, alloy flywheel with 6 puck clutch, all left are the gauges, vacuum lines, a front charge pipe with BOV, and dyno tune. Just have to load that Greddy program to my laptop and we should see what will this little car put down.
Maxima is not my maxima. Is brians maxima, he should be back from Afghanistan this Thurs. Ill post photos later. Total time in labor about a week. Due to stuff being missing and heading to the store a bunch of times.
Jaime
#2
This is indeed my car. I wish I could have been able to do the labor myself, but I'm glad that someone as talented as Jaime was able to do it in my stead. With my deployment schedule, being able to set aside the two weeks that would have been necessary to do the work was not an option.
A big thanks to Jaime for putting up with my incessant e-mails!
A big thanks to Jaime for putting up with my incessant e-mails!
#3
Here is a link to the finished build, along with dyno results.
Another big thanks the Jaime. The fit, finish, and quality of the install was all top notch. I would whole-heartedly recommend him to anyone.
Another big thanks the Jaime. The fit, finish, and quality of the install was all top notch. I would whole-heartedly recommend him to anyone.
Last edited by NousDefions; 07-23-2009 at 06:56 PM.
#6
A 3.00" pulley may be in the cars down the line, along with the 370cc injectors to go with it, but it isn't a priority. The car is WAY more fun than it ever has been, and I've got a second "play" car for when I really need to feel some power.
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM