EMU installed and can't see RPM on live log..???
01-26-2015, 10:26 AM
#1
Senior Member
Thread Starter
Join Date: Dec 2011
Posts: 344
EMU installed and can't see RPM on live log..???
Like the title said...yesterday I swapped from a 99fed ECU to a 95 FED ecu. Cranked up car after swap to make sure no bugs existed. Then shut her down and started on the installation of the EMU. All went well very straight forward. Got done and she fired right up drove her down the block. She wasn't peppy like they normally are but sure that's because it's open header, no 02s hooked up. But as I parked I decided to look at the live log (or what I thought was live log) and it wouldn't show the rpms or anything on the graph.
Is there something in the program that I'm not doing or is there a certail PIN connection I should look at for not having a good connection?
Is there something in the program that I'm not doing or is there a certail PIN connection I should look at for not having a good connection?
04-13-2015, 12:35 PM
#2
Like the title said...yesterday I swapped from a 99fed ECU to a 95 FED ecu. Cranked up car after swap to make sure no bugs existed. Then shut her down and started on the installation of the EMU. All went well very straight forward. Got done and she fired right up drove her down the block. She wasn't peppy like they normally are but sure that's because it's open header, no 02s hooked up. But as I parked I decided to look at the live log (or what I thought was live log) and it wouldn't show the rpms or anything on the graph.
Is there something in the program that I'm not doing or is there a certail PIN connection I should look at for not having a good connection?
Is there something in the program that I'm not doing or is there a certail PIN connection I should look at for not having a good connection?
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM
