Help with Stanza TB
#1
Help with Stanza TB
I just recived it about 5 mins ago , Now this one is a little diffrent the the stock tb
Im going to have to buy some new hosing to install it because the stock hosing is to short , now in the picture below , the stock tb has another place where you connect a little hose , Its just like the red one but on the stock tb there is also one where i have circled in blue , What shall i do about this? , And for the bigger connecters They are for the 2 same coolent hoses right as on the stock?
Im going to have to buy some new hosing to install it because the stock hosing is to short , now in the picture below , the stock tb has another place where you connect a little hose , Its just like the red one but on the stock tb there is also one where i have circled in blue , What shall i do about this? , And for the bigger connecters They are for the 2 same coolent hoses right as on the stock?
#6
2nd Gen Boostinator
iTrader: (14)
Originally Posted by dtm88na
Do you mean that you have an extra vacuum line with no port on the TB? If so, I would buy a tee and tee into an existing line for the vacuum source and just use that instead of a port on the TB.
thats what i did but make shure to get the full effect that you hone out the intake manifold so that it matches the tb properly and also make shure it is smooth...
#10
seems to be a vaccum, It runs up around umm uhh some thing? haha , So what your saying is get a little t connector , That i plug both of the hoses into , and plug the end of it onto , That one place on the tb?
#11
Yeah get a T connector, find an existing line close enough to the line without a port on the TB, cut the existing line you found, insert the T and use the extra port on the T for the line that doesn't have a spot on the TB.
#14
Originally Posted by DJ Technischer
card could you help me out?
#15
sorry i dident mean to post on this one I ment to post for help on whats happening when i drive the car , I have every thing installed , Well i did till i put the stock back on , And for the extra hose i took a t fitting and pluged both little small vaccum hoses up and pluged them into the same port.
Thread
Thread Starter
Forum
Replies
Last Post
lowpost99
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
1
09-08-2015 05:06 AM
sanmaximo2000
5th Generation Maxima (2000-2003)
7
10-17-2003 03:49 AM