Those air/fuel gauges look pretty nice when they bounce back and forth from rich to lean. I would love to get intake and then get the gauge. Anyone have this gauge, if so how did you install it on a max, if you dont mind me asking.

 

yes about 4months ago.
Right in front of your valve cover thee should be two wire harness's. One of them has a red--white--blue wire in it. Tap that white wire and run the to your air/fuel gauge, DONE!

Ant

 

I had the gauge. This gauge is more for looks then purpose. I wouldn't even consider using this gauge to try and tune a car.

 

I have one in my pillar pod...

 

as do i, but i wired it to my ECU o2 sensor return line, not the actual o2 sensor in the engine bay....

 

i tapped into the wire going to my ecu..(from the 02 sensor)


all wiring was done in cabin.. no wiring to the engine

 

great minds think alike

 

 

The WHITE wire? When I did this it just bounced back and forth over and over and over. I thought in the chiltons it said that the white
(postioned in the center) wire is the ground. and it was one of the other 2 wires.


EDIT---I've looked at the Service manual, and the white wire in my car (as stated above) is the center wire wich in the service manual is not the signal wire. The signal wire is diagramed that the #1 position wich is the left.