just like the title asks. how can I run the wire for the switch from the interior to the engine bay. I looked and looked and can't find any holes or rubber stoppers. thanks in advance

 

There is a rubber plug above the fuel filter, it is close it it. That is where I ran my fog wires. The will come out above and to the right of the accelorator pedal.

 

You can always buy the ones I have a GD on lol comes with instructions

 

there is a round rubber seal about 3" wide in the firewall, if you're looking from the engine bay its all the way over on the driver's side about halfway down and if youre looking from the interior its driver's side, far left and you may have to pull back the carpeting a bit to get at it.

 

thanks guys, im gonna have a look in a little bit. gotta do it early in the morning or people think im stealing the car