MaxGR97

I got some new bulbs I want to put in for my corner lights (clearance lights). I can't figure out how to take the actual light out get the bulb out. Anyone have tips on how they did it? Didn't want to break it so I thought I'd ask before I try again.

Ant96GLE

iTrader: (4)

Which one? the one beside the headlight or the one on the bumper?

jackiss2888

iTrader: (3)

just twist and/or pull

superblack99

flathead screwdriver between headlight and clearance light... and then just pry it off.. its pretty hard to get out

MaxGR97

Ya the one right next to the main headlight. Ok I'll go try that pry b/t the two. Anyone else have suggestions?

Ant96GLE

iTrader: (4)

It has one screw... take the screw off and pull that b!tch out... theres nothing else holding it except a small metal snub which you have to pop out by pulling on the entire light

sunten1

wd-40 on the joint

jdm71488

oh wait... let me handle this one!

http://forums.maxima.org/showthread.php?t=326263

monty95

iTrader: (1)

yeah definately, damn thing is a pain to get out.

VIP Maxima

i think there are 2 screws holding it in the place, one on the bottom too.

Nealoc187

iTrader: (23)

No there is only one.

MaxGR97

Alright I'll try that next time. Thanks for that other thread post too.

jackiss2888

iTrader: (3)

****, mine came out pretty easily. in fact, just popped out once i took the screw out. o well

Conrad283

iTrader: (2)

You have to pull as if you're going to break it. There is a small chance that you will break it also because that mother is in there.

monty95

iTrader: (1)

yeah just one screw under the hood. first time i took mine out i did chip it a little...slight small chip....

Luxor99

Just like others said, only one screw and you have to pull pretty hard to get it out. I tried the WD-40 thing with no luck. Just pull the sucker out. On the right one the plastic actually broke and the little pin thing was still the corner of the car. Got it out with pliers and super glued it back on to the corner light. No problems.....until I have to take it out again......

Prodeje79

I took mine to the dealer cuz mine would not come out.

They broke it.

They would not give me a new one. They fixed the plastic with some epoxy or something though.

jdm71488

what? that's some crap!!! what did they say to get out of replacing it?

Prodeje79

I just kinda pulled up to the repair dept. I did not pay anything for them to look at it.

I probably could have pressed the issue and got a new one. I did get the services manager.

I did not even get my max from them haha.