Remote Start Installation

Reply Subscribe

Thread Tools

Search this Thread

01-29-2009, 02:50 PM

#41

pmohr

No more Maximas...

iTrader: (26)

Join Date: Jul 2005

Location: Oak Ridge, TN

Posts: 14,331

Quote:

Originally Posted by TLMNICK

Ok fair enough...I'm gonna try it out, and if it works, then wicked...i wont have to go through the "reservation mode" thing anymore.

Did you get the reverse/neutral wire directly from the switch under the hood, or did you take it from the interior (driver running board)?

As this was a 5MT swap, I had originally just jumped the PN harness (so the car could be started regardless of gear or clutch pedal position) and ran a wire all the way inside to the unit from the engine bay. After looking it over, I just wired it directly to the PN harness.

01-29-2009, 02:54 PM

#42

TLMNICK

Senior Member

iTrader: (1)

Join Date: Aug 2005

Posts: 428

Ok, so as the car sits right now....it wont start if its in any position other than neutral?.....even if the clutch is down to the floor right?

01-29-2009, 02:58 PM

#43

pmohr

No more Maximas...

iTrader: (26)

Join Date: Jul 2005

Location: Oak Ridge, TN

Posts: 14,331

Quote:

Originally Posted by TLMNICK

Ok, so as the car sits right now....it wont start if its in any position other than neutral?.....even if the clutch is down to the floor right?

Correct. My clutch position switch isn't even hooked up, so it's neutral or nothing.

01-29-2009, 03:01 PM

#44

TLMNICK

Senior Member

iTrader: (1)

Join Date: Aug 2005

Posts: 428

Ok....I'm gonna try it out, and report back.

01-29-2009, 08:31 PM

#45

Infowire

Supporting Maxima.org Member

Thread Starter

Join Date: Sep 2005

Posts: 232

Installation Was Successful! "Great Success!"

I had to relay the second starter wire and teach it tach. I will post a write up with pics and diagrams for people that are confused in the future.

01-29-2009, 11:28 PM

#46

ThurzNite

Supporting Maxima.org Member

iTrader: (13)

Join Date: Oct 2000

Posts: 8,489

TLMNICK and pmohr seems to be talking about different sensors. I did it pmohr's method and works fine on my 5sp. Actually, I did it slightly different but used that same wire pmohr's talking about. I tapped it right off the ecu harness, about 2" from the ecu.

Dr J