power window electrical issue
#1
power window electrical issue
so i drive a 95 se, and the only power window that works is the driver one, my first thought was that the window lock was stuck so i switched out the control panel, still nothing. there is power going to the other windows and when i connect the driver control panel to the passenger side i can then roll down the passenger window with the driver button. what is causing this?
#3
I still think you have an issue with the lock signal. Switch, wiring or the drivers door module that the signal goes to.
Check out the FSM in the EL section.
On-board Diagnosis — Mode IV (Power window
monitor) HOW TO PERFORM MODE IV
If I read it correctly the mode will lower the diver window and stop it when lock is depressed.
Check out the FSM in the EL section.
On-board Diagnosis — Mode IV (Power window
monitor) HOW TO PERFORM MODE IV
If I read it correctly the mode will lower the diver window and stop it when lock is depressed.
#4
wait a min man...if u swapped out the passenger panel for teh driver panel, and then it worked. Doesnt that mean that the passenfer panel is blown?
http://www.courtesyparts.com brotha. get a new one.
noobs
http://www.courtesyparts.com brotha. get a new one.
noobs
#5
wait a min man...if u swapped out the passenger panel for teh driver panel, and then it worked. Doesnt that mean that the passenfer panel is blown?
http://www.courtesyparts.com brotha. get a new one.
noobs
http://www.courtesyparts.com brotha. get a new one.
noobs
Last edited by musictech55; 08-27-2010 at 03:52 PM.
#9
Thread
Thread Starter
Forum
Replies
Last Post
The Frye
7th Generation Maxima (2009-2015)
6
09-02-2021 11:03 AM
lowpost99
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
7
05-16-2021 11:18 AM
Maxima30
5th Generation Maxima (2000-2003)
2
09-07-2015 06:13 PM
trungg86
4th Generation Maxima (1995-1999)
7
09-04-2015 04:58 AM