requesti help from lowered maximas
#1
requesti help from lowered maximas
This is a huge favor to ask so I apologize for the imposition ahead of time.
I am looking for someone who has a low/stanced max to take some measurements for me. (By low I mean as close to stanced as possible but can make it over/in most public driveways.) I am trying to get parts for my Maxima project but cannot do this myself as I do not pick the car up until next week.
I would like the following measurements if someone would be so kind (all measurements need to be taken with the coilovers loaded):
1) ouside of lower rim lip (should be able to stick it through the wheel
2) length of coilover from tower to centered pick-up on LCA
Alternate:
1) outside of wheels from side to side measured with a straight edge (both front and back) assuming close to 0 toe
2) top of wheel wells (front and back) to ground
In both cases I need wheel and tire specs plz (sizes and offset).
Pictures of measured condition would be greatly appreciated.
Aproximate measurement deviation would be splended (eg + - 0.25").
.
What I am trying to accomplish is to locate the spindle distance from the body and figure out how wide the overall stance is [of a stanced/low maxima (not battleshiped)]. I am putting in a completely new front and rear subframe and this will tell me if the ones I have will work (otherwise I can start searching for a replacement)... I can go further in to detail in my new build thread if anyone cares to know.
TYSVM for your time! Have a great day; God bless.
-dan
I am looking for someone who has a low/stanced max to take some measurements for me. (By low I mean as close to stanced as possible but can make it over/in most public driveways.) I am trying to get parts for my Maxima project but cannot do this myself as I do not pick the car up until next week.
I would like the following measurements if someone would be so kind (all measurements need to be taken with the coilovers loaded):
1) ouside of lower rim lip (should be able to stick it through the wheel
2) length of coilover from tower to centered pick-up on LCA
Alternate:
1) outside of wheels from side to side measured with a straight edge (both front and back) assuming close to 0 toe
2) top of wheel wells (front and back) to ground
In both cases I need wheel and tire specs plz (sizes and offset).
Pictures of measured condition would be greatly appreciated.
Aproximate measurement deviation would be splended (eg + - 0.25").
.
What I am trying to accomplish is to locate the spindle distance from the body and figure out how wide the overall stance is [of a stanced/low maxima (not battleshiped)]. I am putting in a completely new front and rear subframe and this will tell me if the ones I have will work (otherwise I can start searching for a replacement)... I can go further in to detail in my new build thread if anyone cares to know.
TYSVM for your time! Have a great day; God bless.
-dan
Thread
Thread Starter
Forum
Replies
Last Post
soon2ownmax
6th Generation Maxima (2004-2008)
0
08-13-2015 02:19 PM
laparka66
7th Generation Maxima (2009-2015)
16
08-06-2015 09:36 AM