OK so who has successfully installed a LTBII for a 2000-2003 maxima

I tried and was unsuccesfull. The holes do not match up. We tried everything from torquing down the front first and then trying to match it up but it was about 1/2 inch short to make it work...how did you all do this? please help?

 

there is a link in Matt web site for the installation, u have to loose 4 nuts that bolt the lower control arm in order to had some free play to mount to LTB

here it is, found it:
http://www.blehmco.com/instructionpages/ltb_install.htm

 

i followed those exact instructions..

unfortunately that is a picture of the 4th generation tie bar and not the 5th generation ...the back end bolt is in a diff place for the 5th generation.

i am looking for any 5th gen who has put this on and who has pictures or can tell me how the heck they got it on

 

I think you should just give it to me.

 

haha i might as well since everything I get seemed to go into your hands..So how do the headers feel now after the dyno.

Also you got to help me with the catch can install and this LTB man!!!

 

Give me a call and well get it done!
As for the headers check out my thread and see for yourself I think they had something to do with the hp.LOL
http://forums.maxima.org/showthread.php?t=471519