Safc help
#1
Safc help
hey guys whats going on, i just hooked up my SAFC I and im having a slight problem. it basicly wont rev, its acting like it has a bad maf. i havent changed any settings at all yet (accept making it a 6 cylinder), any suggestions. it is showing voltage from every sensor (tps goes to full voltage). do i need to setup something in the ETC. or something? thanks
#2
Just an educated guess, but from my research on setup of the VAFC you need to select a MAF type somewhere in the options. That would explain why your car's acting like it has a bad MAF, it's unable to read the signal coming from the SAFC. Any codes?
#3
VAFC/SAFC Install and other info
You need to set the in out and the direction under settings I believe. I'd also be sure to do a reset on it if you havnt already, You wouldnt want to ride around with someone elses maps.
You need to set the in out and the direction under settings I believe. I'd also be sure to do a reset on it if you havnt already, You wouldnt want to ride around with someone elses maps.
Last edited by 99Silvermist SE; 05-04-2009 at 06:53 PM.
#4
sorry for the late reply but i figured it out about 5 minutes after i posted. i stupidly didnt pull the ecu lever in all the way and must've had bad contacts for the MAF sensor.
ill post up some dynos after the meet in acouple weeks...
ill post up some dynos after the meet in acouple weeks...
Thread
Thread Starter
Forum
Replies
Last Post
JAY25
General Maxima Discussion
21
10-21-2002 03:15 PM