Removing the two allen head bolts on aftermark exhaust?
#1
Removing the two allen head bolts on aftermark exhaust?
I remember reading something about removing the bolts and pulling the inside out...But not sure for what reason? Is there a modification or something?
http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWNX%3AIT
System sounds pretty damn good. Almost a little too quiet. Sounded better when the system was broke at the axle!!!
Not bad for $150 and free shipping
http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWNX%3AIT
System sounds pretty damn good. Almost a little too quiet. Sounded better when the system was broke at the axle!!!
Not bad for $150 and free shipping
#2
That part at the end that people remove is a silencer. If you take it out, the exhaust will be louder.
What size is the piping on that exhaust? The picture says 2.25 inches, but the description says 2.5...
What size is the piping on that exhaust? The picture says 2.25 inches, but the description says 2.5...
#3
Gotcha. Just wanted to make sure it wasn't something that was not going to go back in once taken out! Ill have to test it tomorrow. I didn't measure it but I can check it out tomorrow. Sure seemed like 2.5 to the eye. Either way, didn't really concern me as I needed a cheap replacement to my broken system. And I wasn't spending $400 bills on something I can really care less about.
#6
Whoa the system is almost too loud w.o that restrictor! Although, does sound quite nice. Im going to cut the tube half way to see if I can be louder then before but quieter then w.o the restrictor. I can get pics for ya.
I did have to cut the lobes on the flange a little bit on the axle back part in order to snake it over the rear suspension brace. And you do have to bend the brackets on the rear muffler alittle (with heat orelse it will snap the weld) so the muffler tip doesn't come in contact with the bumper.
Ill get pics and a sound clip later.
I did have to cut the lobes on the flange a little bit on the axle back part in order to snake it over the rear suspension brace. And you do have to bend the brackets on the rear muffler alittle (with heat orelse it will snap the weld) so the muffler tip doesn't come in contact with the bumper.
Ill get pics and a sound clip later.
#11
I bought the cat-back from eBay seller ILOVETACOTACO (hehe) for only $129.99 shipped. Appears to be the same exact exhaust. 2.5" cat-back with a 2.25" flange for the OEM cat connection.
Also, you appear to have directional tires yet they are installed backwards on the driver side, or not...
Also, you appear to have directional tires yet they are installed backwards on the driver side, or not...
Thread
Thread Starter
Forum
Replies
Last Post
The Frye
7th Generation Maxima (2009-2015)
6
09-02-2021 11:03 AM
lowpost99
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
7
05-16-2021 11:18 AM