Engine stand - Bolts to transmission area
#1
Engine stand - Bolts to transmission area
What are the bolt sizes for a VQ35 where it bolts to the transmission? I think its 12mm with 1.75 pitch, but I want to make sure.
I want to put the motor on my engine stand.
Thanks!
I want to put the motor on my engine stand.
Thanks!
#2
I just went out to the garage to check for you. I still have the bolts I bought for the engine hoist when I pulled my tranny and changed my oil pan seals. I don't have the packaging with the size on them, however it looks like you're right. 12mm, but I could've sworn the pitch was 1.50. Sorry I couldn't be more help. Hopefully, someone else will weigh in here.
#4
I got mine at Lowe's. I had to get a little longer than what I wanted, but I just kept the chain close to the block. It was the coarser of the two they had in stock. You're probably right about the 1.75.
#5
yeah its M12x1.75, 90mm long for the top bolts. Bottom bolts look like m10, and are a lot longer, I used standard for these.
Question, when checking compression, do I turn clockwise or counter clockwise?
Question, when checking compression, do I turn clockwise or counter clockwise?
Thread
Thread Starter
Forum
Replies
Last Post