NmexMAX

iTrader: (22)

www.siliconeintakes has all you need for couplers, pipes, and clamps.

For velocity stacks there's BPi and a few others.

ranmas2004

iTrader: (2)

What is a GAB????

sixteenXnine

iTrader: (2)

Ghetto airbox mod. Remove the tray for the air filter and bend a hanger so that it acts as a retainer, the filter will still press on the airbox with its seal borders... Sounds good and is some people's alternative to a more complex intake setup.

JuiceyMAX

I like this setup!
I think i might go with this in my 3.5, maybe with the jwt pop charger. but GAB (non coat hanger) set up for the time being

luvlexus101

iTrader: (6)

What rad support brackets are those? And your drop resistor is SO shiny haha/

SubwayVQ

Sorry to revive an old thread, but it seemed pointless to make a new thread.

I am planning to do my own intake. I'll buy the MAF adapter kit on eBay and then some 3" tubing and couplers to finish it off. However, I still have not worked out how I will route the PCV hose. I would like to stay away from drilling and RTVing the nipple in, but I don't see any other way. I saw a video of a guy with a mini breather filter thing straight off the VC, but that seemed tacky. Ideas?

Itz Shak

I'm sure Douglas Sands aka Can't Get Ryte could make one for you.

About that mini breather from the VC. Are there any further complications that come with it? Is it safe? I'm thinking about doing that myself.

SubwayVQ

I can't see why it would be an issue. The hose is currently there to let the vapor be burned by the engine for emission purposes. Putting a breather on the end allows the vapors to be released freely in the air. I'm thinking of taking long tubing and putting a breather on the end and hide under the engine so no one can see it.