Ok, this might be very easy for you guys. I don't want my parking lightt & turn signal to come on when I dis-arm/arm the alarm.

How do i do this?

Thanks

 

OEM or aftermarket alarm?

Oem should be flashing the turn signals?
Aftermarket it would be a setting.

 

I don't think you can with OEM. You can toggle the horn off and on though.

 

Guy showed me THIS^ at the meetup. I hate that BEEP BEEP from the horn when you lock the car.

 

OK, how to dis-able the horn then......

Thanks

 

OEM 00 Maxima SE if that makes any different. I guess I'm going to have to tap the power somewhere else. I was going to run my high beam projectors using parking lights for trigger, but then I don't want them to flash when I hit the alarm.

Thanks

 

I can't see them actually coming on, the flash is a super short double pulse, hardly long enough to charge an HID I should think, but I dunno.
Why do you want your high beams to turn on when your marker lights are on??

And to disable/enable the beep, the directions are actually written on the back of your key fab.

"Press both lock & unlock for 2 seconds"

 

[quote=TunerMaxima3000;8393507]
Why do you want your high beams to turn on when your marker lights are on??
[quote]

I'm going to wire my high beam projector on dedicated relay with in-dash switch. I would need a +12V to trigger the relay. Originally I was going to tap the parking light for this purpoe. With this setup, I can toggle the high beam projector on and off whenever I like. I would still wire the selenoid high beam projector together with the one from low beam projector though. Maybe I just go to ignition ACC under the steering wheel and tap the 12+ from there.

Thanks

 

Yeah MSU I'd go with ignition over parking light circuit.