Injen Install Tips?
05-29-2004, 09:24 PM
#1
Supporting Maxima.org Member
Thread Starter
Join Date: Jun 2003
Posts: 2,336
Injen Install Tips?
Looking for some tips about installing the Injen CAI.
I've got it put in already. It seems like the back edge of the filter touches the wheel liner and vibrates at around 5000RPM.
Should I be trying to put as much room as possible between each of the rubber hose joints as possible so the filter can sit further forward?
Does the engine rock forward or backwards with heavy acceleration? I'm trying to figure out where abouts the nut that holds the brace for the downtube should be. Right now its in the center of the track.
Any advice or pics would be appreciated.
CM.
I've got it put in already. It seems like the back edge of the filter touches the wheel liner and vibrates at around 5000RPM.
Should I be trying to put as much room as possible between each of the rubber hose joints as possible so the filter can sit further forward?
Does the engine rock forward or backwards with heavy acceleration? I'm trying to figure out where abouts the nut that holds the brace for the downtube should be. Right now its in the center of the track.
Any advice or pics would be appreciated.
CM.
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM
sdotcarter
6th Generation Maxima (2004-2008)
2
09-02-2015 09:53 PM
Justin Kroll
5th Generation Maxima (2000-2003)
7
09-02-2015 11:06 AM