Service light on
#4
run roof??? is that sun roof???
Just disconnect your battery...
Make sure its pushed to the side not touching any metal...
Go in hte car and turn the car to the "ON" position and hold it there for 15 seconds... Like u would be trying to turn the car on...
Once you have done this for around 20 seconds or so... get out then connect the Pos battery cable...
This should reset it
Just disconnect your battery...
Make sure its pushed to the side not touching any metal...
Go in hte car and turn the car to the "ON" position and hold it there for 15 seconds... Like u would be trying to turn the car on...
Once you have done this for around 20 seconds or so... get out then connect the Pos battery cable...
This should reset it
#5
Originally Posted by Fastmax05
run roof??? is that sun roof???
Just disconnect your battery...
Make sure its pushed to the side not touching any metal...
Go in hte car and turn the car to the "ON" position and hold it there for 15 seconds... Like u would be trying to turn the car on...
Once you have done this for around 20 seconds or so... get out then connect the Pos battery cable...
This should reset it
Just disconnect your battery...
Make sure its pushed to the side not touching any metal...
Go in hte car and turn the car to the "ON" position and hold it there for 15 seconds... Like u would be trying to turn the car on...
Once you have done this for around 20 seconds or so... get out then connect the Pos battery cable...
This should reset it
#6
i have never heard of reseting a sun roof... so i have no idea... what makes you think u need to reset it????
Just make sure its closed... then do what i said... it all will work fine...
Just make sure its closed... then do what i said... it all will work fine...
#7
Yes, you will.
Fastmax05,
If you fiddle with the battery at all, as far as connecting and disconnecting, your sunroof switch will only operate at less-than-half opening.
Your manual tells you how to. I can't remember how, but I do know it was something really simple. Such as 'open all the way, close and open again'....some simple process.
Swee
Fastmax05,
If you fiddle with the battery at all, as far as connecting and disconnecting, your sunroof switch will only operate at less-than-half opening.
Your manual tells you how to. I can't remember how, but I do know it was something really simple. Such as 'open all the way, close and open again'....some simple process.
Swee
#8
Originally Posted by Fastmax05
run roof??? is that sun roof???
Just disconnect your battery...
Make sure its pushed to the side not touching any metal...
Go in hte car and turn the car to the "ON" position and hold it there for 15 seconds... Like u would be trying to turn the car on...
Once you have done this for around 20 seconds or so... get out then connect the Pos battery cable...
This should reset it
Just disconnect your battery...
Make sure its pushed to the side not touching any metal...
Go in hte car and turn the car to the "ON" position and hold it there for 15 seconds... Like u would be trying to turn the car on...
Once you have done this for around 20 seconds or so... get out then connect the Pos battery cable...
This should reset it
#10
Here's the ECU reset info, the timing of each step is critical, some members have reported they had to repeat 4 times or more before they got it right. Also at he bottom is a link to a another reset, but it appears to be the same steps, save for future use.
------ECU reset------
Timing is extremely critical. If it is NOT DONE within the specify time, the ECU will not reset and the Check Engine Light (CEL) will continue to remain ON.
A stop watch or an analog clock with a second’s needle will be useful.
Operations Procedures
1. Confirm that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds.
2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.
2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.
3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking.
4. Fully release the accelerator pedal (while the CEL is still blinking)
5. Wait about 10 second.
6. Fully depress the accelerator pedal and keep it for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to “OFF” position and now you can start the car. The CEL light should be gone.
If the CEL light continues to remain ON, repeat the above steps. Timing is EXTREMELY critical to resetting the ECU.
http://maxima.theowensfamily.com/ecu.asp
------ECU reset------
Timing is extremely critical. If it is NOT DONE within the specify time, the ECU will not reset and the Check Engine Light (CEL) will continue to remain ON.
A stop watch or an analog clock with a second’s needle will be useful.
Operations Procedures
1. Confirm that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds.
2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.
2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.
3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking.
4. Fully release the accelerator pedal (while the CEL is still blinking)
5. Wait about 10 second.
6. Fully depress the accelerator pedal and keep it for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to “OFF” position and now you can start the car. The CEL light should be gone.
If the CEL light continues to remain ON, repeat the above steps. Timing is EXTREMELY critical to resetting the ECU.
http://maxima.theowensfamily.com/ecu.asp
#11
Originally Posted by Lovemycar
Again will i need to reset my SUN ROOF
#14
Originally Posted by Lovemycar
Guys can some one help me with this i can't get this to work i know nothings
wrong with my car
wrong with my car
#16
Thanks guys i did try both things but they didn't work i couldn't get the ses light to blink and disconnecting the batt no go either so i just went to
auto zone and had then reset it for me with there reader thingy and it's all good now just need to remember to plug that MAF in after changing air filter
thanks again guys for your help
fastmax5 nice mods
auto zone and had then reset it for me with there reader thingy and it's all good now just need to remember to plug that MAF in after changing air filter
thanks again guys for your help
fastmax5 nice mods
#17
Originally Posted by Lovemycar
Thanks guys i did try both things but they didn't work i couldn't get the ses light to blink and disconnecting the batt no go either so i just went to
auto zone and had then reset it for me with there reader thingy and it's all good now just need to remember to plug that MAF in after changing air filter
thanks again guys for your help
fastmax5 nice mods
auto zone and had then reset it for me with there reader thingy and it's all good now just need to remember to plug that MAF in after changing air filter
thanks again guys for your help
fastmax5 nice mods
As for my mods, thanks! i have a few things on the way too... Stillen lip in a few weeks... SACF2 and the Ypipe from cattman should have around 300hp to the fly... not tooo shabby
Thread
Thread Starter
Forum
Replies
Last Post
fastcarny
5th Generation Maxima (2000-2003)
2
10-06-2015 10:42 AM
Maxima30
5th Generation Maxima (2000-2003)
2
09-07-2015 06:13 PM