Im looking for local (So Cal) makers of CF so I can pick up a sheet. Then I could trace my ABS splitter onto the CF sheet and cut out the shape and bolt it on.

 

I am resurrecting the splitter thread. My splitter broke last year and I am rethinking the project. I have the broken splitter so I can work with that. I am going to glue it back together, but then use it as the base to fiberglass over it. I also want to have the splitter meet up with my Stillen lip so it looks smoother. I never liked the gap in the prior splitter so my plan it so fill in the gap. If you go to www.stillen.com and look at Stillen's splitter, you can see that there isnt much of a gap between the splitter and the bottom of the car.

 

Good lord Deus. When you resurrect you don't mess around!

 

Well its better than starting a new thread, I suppose I could always do that, eh?

 

Hey thought this to be interesting design by nissan for the new Nissan Leaf. It looks like the rear end has a plate similar to the front of the car.

 

Picture = Red X ????

 

I appologize I couldn't see it myself, I am on a NMCI computer which blocks just about every picture due to security. It is on the Nissan News site. I will provide a link.

 

http://www.nissanusa.com/leaf-electr...mepage.Home.P3 It is image 5 of 18 in the Gallery.

 

Um, thats a rear diffuser, not a front splitter

 

yep diffuser, i seriously thought that was what you were talking about. i just remember you making one 4 your car

 

You're right. I did make a rear diffuser a couple years ago before I found my JDM Evo rear diffuser that I have now. This thread is regarding my front splitter.
I epoxied the two broken pieces together. I might put more epoxy in there. Then I will begin laying the fiberglass. Ill keep ya'll posted as usual.