Stillen Cold Air Intake and Exhaust
#43
thanks for the help
#46
This is absolutely incorrect, the Stillen Intake taps into the existing fresh air inlet and will not be drawing in hot air, you will gain 8 to 10 HP
The intake wont gain you anything. It will cause you to loose power. It will draw hot air from the engine compartment and likely will hurt your gas mileage.
Nissan put a lot of work into getting this revised VQ to run cooler, you are best off with a drop in filter, or waiting for an actual cold air intake.
Nissan put a lot of work into getting this revised VQ to run cooler, you are best off with a drop in filter, or waiting for an actual cold air intake.
#47
Glad to hear the outside fresh air is in the loop on this add on. Still (no pun intended) I wonder if they is REALLY any measurable difference other than making more induction noise. I still say, "wrong car" to cowboy up.
#48
From every report I have read on this Intake, their is a noticeable increase, better throttle response and of course it is louder, I did a lot of research on this before I made the decision to buy, It is the only one I could find that is CARB Exempt. I will install it this weekend so I will let you know. I get the "wrong car" to cowboy up comment, the car is pretty cool as is and you don't really need to Mod it up. Despite that fact I have decided to add the Stillen CAI and Axle Back Exhaust because I want the sound that comes with it. The added performance boost is also a benefit. Hell if I don't like it I can always just put the factory airbox back on, it isn't like it is a hard install or anything like that. I like the fact that it taps in the factory cold air tube.
These Mods by Stillen also don't require any special tuning, so why not?
These Mods by Stillen also don't require any special tuning, so why not?
#52
#54
So far I like it! I installed the Intake this weekend, and it sounds great, and I also noticed a power boost on the low end, didn't really notice anymore power under full throttle but on the low end yes, also better throttle response, it took a couple days for the ECU to adjust but after that it is great! I also noticed better gas mileage, my average MPG went from 22 to 23 after a couple days.
I cant wait to install the Exhaust now.
I cant wait to install the Exhaust now.
#56
I installed the Stillen Intake over the weekend and cant wait to install the Axel Back Exhaust, I noticed better Gas mileage, better sound and more power on the bottom end after the ECU had time to adjust. I would say it is worth every penny!
#57
Stillen intakes are crap as with most of their overpriced Chinese made stuff...lol
#58
def worth it, loved the sound combo of the stillen exhaust and intake on my max. get a pedal commander too :
#61
Old post, but since this thread was resurrected, I will say that it's hard to feel 8 to 10hp on the butt dyno... It generally takes about 20-25hp to be felt on the butt dyno....
#62
#64
Stolen cat back
Have a 2017 SR. Installed a Stillen cat back. Also installed a Y pipe. Stock Y pipe is very restrictive. Y pipe they claim 15-20 pounds of torque extra. But ya you will notice great improvement . My best gas mileage I got so far is like 32 mpg. But also have a ODB chip. Think that helped a bit
#65
Have a 2017 SR. Installed a Stillen cat back. Also installed a Y pipe. Stock Y pipe is very restrictive. Y pipe they claim 15-20 pounds of torque extra. But ya you will notice great improvement . My best gas mileage I got so far is like 32 mpg. But also have a ODB chip. Think that helped a bit
#67
Uprev is the license you have to buy to tune your ECU, they are the only one available for the 7th gen. They are also said to have limited support for the early 8th gens. I got the y-pipe with a borla catback, and it definitely feels faster by a bit.
#68
I’m running the oiled Stillen intake and Stillen cat back exhaust on a 17 SR (and their rear sway bar for what it’s worth). Car feels peppier in traffic which is great but the real thing that puts a smile on my face is how she sounds now.
#69
Stillen pipe
Totally agree with you. Love it myself. I removed the silencer tube in front of air filter box and running a dry foam air filter. Not sure if I’m gonna bother buying a Stillen cold air. Just trying to find some bolt ins to wake it up a bit more. Have you thought of remapping computer? Or is it even worth it?
#70
Totally agree with you. Love it myself. I removed the silencer tube in front of air filter box and running a dry foam air filter. Not sure if I’m gonna bother buying a Stillen cold air. Just trying to find some bolt ins to wake it up a bit more. Have you thought of remapping computer? Or is it even worth it?
Last edited by ENGINE2MAXIMA; 10-30-2019 at 07:54 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Adamlavigne
7th Generation Maxima (2009-2015)
7
05-02-2016 08:43 PM
I H8 COPS
4th Generation Maxima (1995-1999)
10
04-01-2003 04:53 PM
Weasel
General Maxima Discussion
12
06-25-2001 04:20 PM