Kenwood Sirius H2A install in 3rd Gen (How to cut ABS plastic?)
#1
Kenwood Sirius H2A install in 3rd Gen (How to cut ABS plastic?)
Hey,
I have a Kenwood H2A Sirius PNP in a 3rd Gen GXE. I've decided to mount it where that POS drawer and bastard cupholders are. I've got an inline fuse adapter, the heatshrink and soldering iron. But I don't know how to properly cut the ABS plastic sheet I bought to make a faceplate out of. Does anyone have any good links on cutting this stuff?
I'll be sure to post pictures of the install after it's complete. I'm tired of the wires all over my car between the radar detector, the sirius tuner, and the fugly 1 to 4 cigarette lighter adapter they sell at BestBuy to plug them both in.
Thanks.
Jeff
I have a Kenwood H2A Sirius PNP in a 3rd Gen GXE. I've decided to mount it where that POS drawer and bastard cupholders are. I've got an inline fuse adapter, the heatshrink and soldering iron. But I don't know how to properly cut the ABS plastic sheet I bought to make a faceplate out of. Does anyone have any good links on cutting this stuff?
I'll be sure to post pictures of the install after it's complete. I'm tired of the wires all over my car between the radar detector, the sirius tuner, and the fugly 1 to 4 cigarette lighter adapter they sell at BestBuy to plug them both in.
Thanks.
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
ViciousVQ30
4th Generation Classifieds (1995-1999)
0
08-05-2015 05:40 PM