I want to bleed the brake fluid on my max and the Haynes manual says to first "disconnect the 4 electrical connectors to the ABS actuator" I looked up the diagram but it shows 4 connectors only for 1995-96 models, and i cannot find a diagram for a 1997-99 model. I looked near the actuator and found 2 bundles of wires coming out of it, leading to only 2 "snap-type" connectors nearby the actuator on the right side of the engine compartment (vs. on the left side in 1995-96 models). Are these the only 2 connectors i need to disconnect for the ABS actuator? Thanks for any help you can provide.

 

disconnect the battery , than go ahead with brake bleeding , just make sure you don't push the brake pedal all the way to to floor ( by doing that you could damage Master Cylinder)

Nick.