steven88

iTrader: (28)

So I recently did a brake job on my car...I sent the rotors off to pepboys (to get resurfaced) and came back home and waited...while that was happening, I decided to prep my pads by adding anti squeal gel on the shims...and pushing the piston back in with a C-clamp...problem is, when I pushed the piston back in, the brake fluid overfilled.... so I took the cap off caught it with a few towels...

Now the thing is, I forgot to put the cap back on...and I went back inside the house...then a few hours later, I drove off to pepboys to pick up my rotors and AFTER I reassembled everything, is when I found out the cap on the brake master cylinder was still off....is this bad?

The fluid has been recently flushed (i'd say 8 months old) and the cap was off for 3-4hrs I'd say....will my boiling point be bad? I don't drive too hard...mostly city driving and nothing too crazy...

CCS2k1Max

iTrader: (2)

If you want to play it safe, remove the fluid from the reservoir with the old baster trick and refill it with fresh fluid. I doubt moisture has difused into the lines yet.

steven88

iTrader: (28)

NIce! Thats all I really needed to know...