I need help with the wiring of the VI...

I've got the manifold installed, just have to wire it all. I used the vqpower write up but the diagrams aren't much of a help.... anyone who has done the install or know where another write up is, please let me know.... thanks.

 

anyone with a mevi?

 

best person to ask is Ian (iansw)

 

http://forums.maxima.org/showthread....ht=mevi+wiring

 

That works, too Way to use your searching priveleges

 

man mevi wiring looks kinda hard. I hope someone makes a good wright up soon. Good luck man.

 

Where would i get the vacuum line from? I can't find which hose to use, the pictures i see are from 95's or 96's, I've got a 97.

 

Get the vacuum from the fuel pressure line.

 

It's easy.

2 wires to battery (1 for RPM switch and 1 for Vaccuum soleniod)

1 wire to GND from RPM switch

1 wire from coil pack to RPM switch(if using harlan)

1 wire to RPM swithc from soleniod.

Thats it in a nutshell

 

Where would the relay go in at? Does it help or hinder to have the relay in? Will it keep the intake from opening up? I've read alot about peoples Harlans not working properly, i assumed this was because of bad installs...

 

I did not use a relay, and my Harlan has worked flawlessly so far. I tapped the RPM signal of a coil pack.

 

Thanks to everyone who helped.... I've got my VI on and it has worked great so far... Cant wait to get to the track, You were a great help.