To all with 3.33 pulley
#2
I ordered the 3.33 pulley from Vortech. However, my supercharger is still sitting in my room. I'm going to wait until Matt is free to help me with the supercharger install, then we can swap in the 3.33 pulley. The stock belt "seem" to fit fine with the 3.33 pulley. I'm not completely sure if that's the case since I didn't take the stock pulley out and test fit with the 3.33 pulley. I would also like to know if the stock belt will fit the 3.33 pulley. And yes, if new belt is needed, please provide with the part number.
#7
I don't know the part number, but I just went to AutoZone and asked for a 6 ribbed 69.5" belt. That worked fine for 3.48" as well as 3.33". The next smaller size they had available was way too small.
By the way, if anyone wants to buy my 3.48" pulley, you can get it "really" cheap from me. It's little beaten up and such but fully functional. I originally got it from Vortech for $60 and some change I believe. Email me and I can take some pics and send since it isn't doing any good sitting in my garage.
By the way, if anyone wants to buy my 3.48" pulley, you can get it "really" cheap from me. It's little beaten up and such but fully functional. I originally got it from Vortech for $60 and some change I believe. Email me and I can take some pics and send since it isn't doing any good sitting in my garage.
Originally posted by bosco500
do you know a part # on a smaller belt?
do you know a part # on a smaller belt?
#8
Originally posted by SighMax
I don't know the part number, but I just went to AutoZone and asked for a 6 ribbed 69.5" belt. That worked fine for 3.48" as well as 3.33". The next smaller size they had available was way too small.
By the way, if anyone wants to buy my 3.48" pulley, you can get it "really" cheap from me. It's little beaten up and such but fully functional. I originally got it from Vortech for $60 and some change I believe. Email me and I can take some pics and send since it isn't doing any good sitting in my garage.
I don't know the part number, but I just went to AutoZone and asked for a 6 ribbed 69.5" belt. That worked fine for 3.48" as well as 3.33". The next smaller size they had available was way too small.
By the way, if anyone wants to buy my 3.48" pulley, you can get it "really" cheap from me. It's little beaten up and such but fully functional. I originally got it from Vortech for $60 and some change I believe. Email me and I can take some pics and send since it isn't doing any good sitting in my garage.
#13
Originally posted by Y2KevSE
Read the date on these posts.
Read the date on these posts.
But on another topic what size belt is used for the 3.25 pulley, and is gates one of the better brands of belts, if so where do you guys order them from (pepboys,autozone???)
#15
Originally posted by Y2KevSE
Stick with Gates... K060705
Stick with Gates... K060705
http://forums.maxima.org/showthread....hreadid=126657
I know this would be very helpfull.
Thread
Thread Starter
Forum
Replies
Last Post
My Coffee
New Member Introductions
15
06-06-2017 02:01 PM
rbarnes
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
4
12-31-2015 06:29 PM