Hey everyone, I have a 5spd 4th gen. I looked at a couple installations on auto 4th gens and the power wire was ran thru that rubber area in the firewall. However, on my 5spd, there is already a stock wire going thru it and the power steering cannister is in the way too. Does anyone have any ideas where to drill on a 5spd? Thanks.

PS - I'm running 0ga so I can't just run it thru the stock hole.

 

just threaded the power wire through a hole in the engine compartment, down into the left wheel well (behind the plastic wheel well guard on the inside), then through a large rubber stopper with a wire harness going through it already, into the driver's foot well near where the hood release cable comes through.

 

hehe...Parsec, you're funny.
That's the same place I'm gonna run my wire. And while I'm in the wheel well, I think I'll mount my fuse box there.
Jae