Does anyone know what the size of the screw (thread/pitch) that are holding the OEM FPR? I rather go buy it before hand. Should I replace the o-ring or just reuse the on that's on the stock FPR?

 

just reuse the o ring you have.

 

don't remember the size but the fuel injector cap screws fit iirc...

 

Tony, i'm guessing but IIRC M8 x 1.5 (possibly 1.25) pitch?

 

I'll just get both. Thanx for the info.

 

Can you post a pic of the AEM fpr?? Thanks

 

They are smaller than M8. M6, I believe.

 

After contemplating it after my long drive to San Jose... The pitch was probably smaller than 1.25 even... I knew I should have written it down when I did it.... Sorry Tony...

 

--Paul

 

The AEM FPR is in. My good digital camera is still in Colorado for warranty repair so no pictures for right now. I might take a few pics with my old digi. My FP is perfect now. 34psi at idle and 43 at WOT. I used the smallest orifice and it works fine.

 

I had to use my old digital camera for these pics...I apologize for the poor quality.





The rest of in here. I'll take some more when I get back my good camera.

http://public.fotki.com/1max2nv/1max...fuel_pressure/