HELP ! McCulloch Xenon HID kit installation
#1
HELP ! McCulloch Xenon HID kit installation
Hi!
I have a problem with my HID kit. The Mcculloch connector that is going to conect to my factory connector has only 2 wire : BLack and white. But the factory connector has 3 wires: Left lamp has Black/ Blue with blue strip/ Green , Right lamp has Black/ Green with yellow strip/ yellow.
How can I do the installation.........
I have a problem with my HID kit. The Mcculloch connector that is going to conect to my factory connector has only 2 wire : BLack and white. But the factory connector has 3 wires: Left lamp has Black/ Blue with blue strip/ Green , Right lamp has Black/ Green with yellow strip/ yellow.
How can I do the installation.........
#2
Member who somehow became The President of The SE-L Club
iTrader: (19)
Join Date: Jun 2001
Posts: 16,033
Your new HID's have no high beams. You only need 1)Power and 2)Ground.
Your 9004 socket has 3 leads. 1)Low beam power 2) High beam power and 3)Ground.
I can't remember which is which, but you only need the low beam power and ground for you new HID's.
Looking at the socket, I'm pretty sure the middle is ground. You can play around from there to see which one will have power when your lights are on.
Your 9004 socket has 3 leads. 1)Low beam power 2) High beam power and 3)Ground.
I can't remember which is which, but you only need the low beam power and ground for you new HID's.
Looking at the socket, I'm pretty sure the middle is ground. You can play around from there to see which one will have power when your lights are on.
#3
Re: HELP ! McCulloch Xenon HID kit installation
Originally posted by YUTAKARNB
Hi!
I have a problem with my HID kit. The Mcculloch connector that is going to conect to my factory connector has only 2 wire : BLack and white. But the factory connector has 3 wires: Left lamp has Black/ Blue with blue strip/ Green , Right lamp has Black/ Green with yellow strip/ yellow.
How can I do the installation.........
Hi!
I have a problem with my HID kit. The Mcculloch connector that is going to conect to my factory connector has only 2 wire : BLack and white. But the factory connector has 3 wires: Left lamp has Black/ Blue with blue strip/ Green , Right lamp has Black/ Green with yellow strip/ yellow.
How can I do the installation.........
Thread
Thread Starter
Forum
Replies
Last Post
The Frye
7th Generation Maxima (2009-2015)
6
09-02-2021 11:03 AM
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM