I bought my 95 max last year in may the starter was bad i changed it the car give some problem to start up i changed crank position sensor the sub harnest.i fanally tought that the problem was fixed but this morning i went out to start it but it wont start up it just keep cranking. its only really bad when its cold.

 

when last was your fuel filter chaned?

you checked both crank position sensors?

 

i recently changed the gas filter and i replaced the crank sensor by the front pully

 

Crank sensor POS will cause a no start condition. It's located under the car on the transmission bell housing. It looks at the flywheel.

Check the resistance of the engine coolant temp sensor. Make sure it's within specs at the specified temperature. If it's not, change it.

 

i changed the coolant sensor already. does any one think its a bad ecu harnest.the car also have 167k miles.

 

Ignition switch might be the problem.Replaced mine 2 yrs ago and never had starting problem again

 

i have the ssame problem, how do u check the ects?