supergondi

so i notice some hesitation on my 98 se sometimes on acceleration usually right after i start it when i hit 3k but it doesnt happen all the time. so i changed the plugs and noticed #3 plug had some powdery white substance on it just the part that sticks out the combustion chamber. i grabbed a couple new coils from work and changed the one out started it and 2mins later yellow light and p 1320 ignition failure so i went to the next coil after clearing code same thing except this time the tach jumped to 4500 key on engine off and stayed there after i removed key i dont have plastic over the gauges so i zeroed the needle out by hand went back to the original coil and it works fine again no light there was no light in the begining either i just thought that one coil may have leaked or melted a bit but i guess not. any members have any thoughts??

tigersharkdude

iTrader: (20)

What kind of coils did you use? For ignition coils it's OEM or BUST

Also what kind of plugs did you use? NGK or BUST on plugs

supergondi

i feel the same ngk or bust but i work at a napa ny warehouse and ive had good luck with everything else so i went with those too and i will bow to the forum they are trash ill stick to used oem ones my success rate is way better.

edwardh1

my mechanic (store front, employs 3 other mechanics) tried a napa coil that cured the miss but turned on the check engine light. he took it back, got oem from nissan, end of problem. too much stuff from china