FSTB Installation
FSTB Installation
Ok, so installed it the first time around, and as expected got the knocking like noise, so did the:
From the How-To thread, and it still hit, but barely...(if looking at the engine, it's the part towards the driver's side) So I tried doing two washers on that sturt tower. I just took it all off because it still hit, and I didn't want to go for three as I was out of washers, and I wasn't sure if the nuts themselves would have enough grip after that, any suggestions?
Edit: This one if it helps.
NOTE FOR '02/'03 MAXIMAS:
For '02/'03 Maximas, there can sometimes be problems where the FSTB will not clear the intake manifold collector when the car is in reverse which will cause a knocking sound. If this is the case, add the following step between steps 2 and 3 above:
- Place a 3/8" or 10mm washer over each tower bolt.
For '02/'03 Maximas, there can sometimes be problems where the FSTB will not clear the intake manifold collector when the car is in reverse which will cause a knocking sound. If this is the case, add the following step between steps 2 and 3 above:
- Place a 3/8" or 10mm washer over each tower bolt.
Edit: This one if it helps.
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
Jun 27, 2019 01:37 PM