Write-up for Berk install? (i've searched_
#1
Write-up for Berk install? (i've searched_
I looked in the how to's and searched but im not able to find any write-ups for a berk intake install. Can someone please point me to the right direction?
Thank you
Thank you
#2
Wirth enough common sense, this should help get you there.
http://forums.maxima.org/showthread....681#post283681
Or like this, but again, tailor your intake to the one pictured. http://www.geocities.com/nismorg/Maxima/cai.html
Not hard, very easy.
http://forums.maxima.org/showthread....681#post283681
Or like this, but again, tailor your intake to the one pictured. http://www.geocities.com/nismorg/Maxima/cai.html
Not hard, very easy.
#5
2002 maxima se
iTrader: (7)
Join Date: Apr 2006
Location: BUENA PARK, CA (orange county)
Posts: 1,082
if you were able to put those 3 vaccum hoses on the berk then you did fine. rremember that the big vaccum hose will often slip off so buy a small clamp for that to keep it tight. dont overtie it because that will break the hose when the temprature is high. and about that sensor check this thread http://forums.maxima.org/showthread.php?t=507207 because i had the same question when i first installed the berk. you should leave that sensor in the air scope if not then you have the option to ziptie that sensor.
EDIT: if the car runs fine after the installation then dont worry about that sensor or any tube/wire. as long as you dont have the SES light or hesitation of idle etc.
what year is your car it seems 2k maxima to me.
EDIT: if the car runs fine after the installation then dont worry about that sensor or any tube/wire. as long as you dont have the SES light or hesitation of idle etc.
what year is your car it seems 2k maxima to me.
#9
Bro, you seriously need to give that engine bay some TLC.
Here...
http://autopia.org/forum/guide-detai...detailing.html
Here...
http://autopia.org/forum/guide-detai...detailing.html
#10
Originally Posted by clayman88
Bro, you seriously need to give that engine bay some TLC.
Here...
http://autopia.org/forum/guide-detai...detailing.html
Here...
http://autopia.org/forum/guide-detai...detailing.html
that **** is nasty!!!!
an engine bay should look like this (and this is on a "dirty" day)
#13
Originally Posted by soonerfan
his engine hates him!!
that **** is nasty!!!!
an engine bay should look like this (and this is on a "dirty" day)
that **** is nasty!!!!
an engine bay should look like this (and this is on a "dirty" day)
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM