nismomaxx

I recently had my clutch changed, after the clutch swap my car threw a Service Engine Soon light, I have a OBD2 reader and the codes were Camshaft Positioning Actuator Banks 1 & 2.

After doing some research, that partciular piece is under recall... Mine never got replaced, therefore I'm going to get my swapped. Figured I'd post it up, and let everyone know.

http://www.internetautoguide.com/aut...ima/index.html

Pulled directly from that website :

Recall Summary
ON CERTAIN PASSENGER VEHICLES, THE CIRCUIT BOARD FOR THE CRANK POSITION SENSOR OR CAM POSITION SENSOR MAY HAVE AN IMPROPER SOLDER JOINT DUE TO SOLDER DEFORMATION CAUSED BY HEAT STRESS ACCELERATED BY THE EXISTENCE OF FLUX RESIDUE DURING THE SOLDERING PROCESS.

Consequence
THIS COULD CAUSE THE "SERVICE ENGINE SOON" WARNING LIGHT TO COME ON, CREATE A NO START CONDITION, CAUSE REDUCED ENGINE POWER, OR CAUSE THE ENGINE TO STOP RUNNING WITHOUT WARNING DURING VEHICLE OPERATION, WHICH COULD RESULT IN A CRASH.

VQP0WER

Well, if your car is not effected by the recall, here are the possible causes:

pick-up portion of the camshaft