Hello all I noticed my front Strut to Knuckle bolts were loose i was hearing a chatter at times when pulling into the driveway--The tires are wearing perfect and i have no drift or pulling--I tightened each both up while froint of car was jacked up--Drove car after that--No more noise and no pull or drift.. Is there an Alignment adjustment where the strut mounts to knuckle didnt see any cams or anything.. All i did was simply tighten the bolts! Thanks..

 

Actually does make a difference, you can push and pull the knuckle, then tighten bolts. Pushing in with throw steering wheel off, pulling spindle out then tightening works best.

 

Thank you!

 

I had one half axle replaced and I always felt a slight pull on that side. Nothing signiifcant but definitely a feel. Probably due to a small difference in length.

 

There's not enough play in the strut bolt bores to make a difference unless someone enlarged the strut bolt bores