Maxima aluminum tiedown!
#44
Ya'll are more than welcome to pay now. But we can wait until I have the parts in hand that way there are no screw ups. But make sure you PM me. That way I can keep a list and will contact everyone back once I get the parts in hand.
Last edited by sicivic89; 05-27-2008 at 05:18 PM.
#46
#47
Licensed to Spell
iTrader: (12)
Join Date: Feb 2001
Location: Murrieta (southern California)
Posts: 4,521
Hmmm.... good point. But I promise you, I literally have my shaved '99 Maxima emblem here in my office at work. The A's are crossed from the left leg. But this is the '97/'99 'attached' MAXIMA, perhaps the '95/'96 'detached' is different? I'll check when I get home because I have that too.
#52
Licensed to Spell
iTrader: (12)
Join Date: Feb 2001
Location: Murrieta (southern California)
Posts: 4,521
O.k., here is a pic. of the '95/'96 M A X I M A and the '97/'99 M_A_X_I_M_A
Like I said before, the A is crossed from the left leg of the A, not the right. I can't believe Maxima.org is wrong! Also, you'll note different leg widths on the M, A and X's, if you want to get technical. Also, note that the angle of the letters is much different than the Maxima.org above, which almost look italicized.
Like I said before, the A is crossed from the left leg of the A, not the right. I can't believe Maxima.org is wrong! Also, you'll note different leg widths on the M, A and X's, if you want to get technical. Also, note that the angle of the letters is much different than the Maxima.org above, which almost look italicized.
#53
^^ pshh....nobody cares about 4th gens
besides, if you use the exact same lettering, that could be considered trademark infringement (note that "Maxima.org" is not an "authorized by Nissan" site....)
besides, if you use the exact same lettering, that could be considered trademark infringement (note that "Maxima.org" is not an "authorized by Nissan" site....)
#55
Licensed to Spell
iTrader: (12)
Join Date: Feb 2001
Location: Murrieta (southern California)
Posts: 4,521
You're right. I rarely leave the SCed or 4th gen forums so I forgot I wasn't in the 4th gen forum - lol. I was thinking only in terms of 4th gen. I tried to look at a badge on a 6th gen. last night on the way home and, while we were doing 65 mph, I do believe the tie down and .org banner match the 6th gen emblem.
#60
#69
they are in!
The bars are in and they look great! I will posting a new thread under the classifieds here shortly since this isn't a general maxima discussion anymore. Thats unless the mods over move this thread over.
#77
#78
Either way I'm buying one
Thread
Thread Starter
Forum
Replies
Last Post