5th Gen "I AM NEW HERE BUT HAVE A QUESTION" thread
#2882
Originally Posted by koolguy4u
Mine works fine though. Its just occasionally that it opens by itself when i bearly start the car, or like a min or 2. But im goin to read the manual in the morning, see if it has anything that would help. thanks
What does 'barely start the car' mean, exactly?
#2883
I did read the thread and it talks about when you disconnect the battery, it causes your sunroof not work completely (like it don't work)and you have to activate it(shows you in the owner manual). "Bearly start the car" means when i turn the ignition is on to turn the car on. Its not just in the morning nor the first time of the day. Its anytime it can happen.
#2886
Originally Posted by TeH BawNeY
I want to clean the inside of my headlights as over the 7 years they've gotten kinda yellow. My mom always drove it and she just gave it to me recently so I'm starting to fix it up etc.
How do I go about cleaning them?
Its a 2000 se btw.
How do I go about cleaning them?
Its a 2000 se btw.
http://forums.maxima.org/showthread.php?t=443410
#2887
Originally Posted by bjr
So i finally got an 2000 GLE handed down to me.
First thing.
Headlights?
Not planning on going HID but what are the the best Halogen bulbs for this car in your opinion. Also where can I find them.
Next.
Fog Lights.
I want the JDM yellow fogs. Will these work?
http://www.automotivelightingusa.com...roducts_id=983
First thing.
Headlights?
Not planning on going HID but what are the the best Halogen bulbs for this car in your opinion. Also where can I find them.
Next.
Fog Lights.
I want the JDM yellow fogs. Will these work?
http://www.automotivelightingusa.com...roducts_id=983
I don't know about those fogs.... This might help you though. http://forums.maxima.org/showthread.php?t=449650
#2888
I have clanking noise coming from the right rear wheel side, especially when i run on bumps. It sounds like something is loose. But when I took a glimpse underneath the car, it seems like everything intact. Could it be the exhaust or muffler?
#2890
I have a 2000 Maxima Automatic with 54K miles on it.
I have had a coil that go bad on me a week ago and I was getting constant misfire with the usual TCS/SES/SLIP indicators on. About three days ago the new coil arrived but the ABS light suddenly went on. I replaced the coil and cleared the codes for the OBD and SES and SLIP went away. However, the ABS and TCS OFF lights are still on. I reset the OBD again and then removed the battery link and its still there. Anybody got any clues? I searched all over the place for TCS + ABS but haven't found anything conclusive. Basically, the TCS and ABS lights don't light until about two seconds after the car is started.
Is it an ABS sensor failure? Or alternator Failure? Or do I need to flush my break fluid? Help? Anybody seen this before?
I have had a coil that go bad on me a week ago and I was getting constant misfire with the usual TCS/SES/SLIP indicators on. About three days ago the new coil arrived but the ABS light suddenly went on. I replaced the coil and cleared the codes for the OBD and SES and SLIP went away. However, the ABS and TCS OFF lights are still on. I reset the OBD again and then removed the battery link and its still there. Anybody got any clues? I searched all over the place for TCS + ABS but haven't found anything conclusive. Basically, the TCS and ABS lights don't light until about two seconds after the car is started.
Is it an ABS sensor failure? Or alternator Failure? Or do I need to flush my break fluid? Help? Anybody seen this before?
#2892
Originally Posted by dsx724
I have a 2000 Maxima Automatic with 54K miles on it.
I have had a coil that go bad on me a week ago and I was getting constant misfire with the usual TCS/SES/SLIP indicators on. About three days ago the new coil arrived but the ABS light suddenly went on. I replaced the coil and cleared the codes for the OBD and SES and SLIP went away. However, the ABS and TCS OFF lights are still on. I reset the OBD again and then removed the battery link and its still there. Anybody got any clues? I searched all over the place for TCS + ABS but haven't found anything conclusive. Basically, the TCS and ABS lights don't light until about two seconds after the car is started.
Is it an ABS sensor failure? Or alternator Failure? Or do I need to flush my break fluid? Help? Anybody seen this before?
I have had a coil that go bad on me a week ago and I was getting constant misfire with the usual TCS/SES/SLIP indicators on. About three days ago the new coil arrived but the ABS light suddenly went on. I replaced the coil and cleared the codes for the OBD and SES and SLIP went away. However, the ABS and TCS OFF lights are still on. I reset the OBD again and then removed the battery link and its still there. Anybody got any clues? I searched all over the place for TCS + ABS but haven't found anything conclusive. Basically, the TCS and ABS lights don't light until about two seconds after the car is started.
Is it an ABS sensor failure? Or alternator Failure? Or do I need to flush my break fluid? Help? Anybody seen this before?
#2894
Originally Posted by dsx724
CRAP, now i'm only get 1320...errr...now i have replace all my coils....
#2895
I think my car is trying to mess with my head. Here's the series of events:
Day 0: SES light comes on, I get code p1320 and misfire in cylinder 6. Tested resistance of coil: 3.3M ohms #Bad
I order new coil.
Day 1: SLIP and TCSOFF lights come on, some occasional shaking. #EXPECTED
Day 3: ABS Light turns constant #WTF Never Seen This Before, stops driving car and wait for coil
Today part 1: Coil Arrives/Installed, Reset OBD, ABS + TCS Still On #ERR
Today part 2: Disconnect Batt and ABS TCS SES SLIP All ON #!!!!
Today part 2 cont: OBD 1320 No Cylinder Misfire Code #???
Today Part 3: Reset OBD, ABS and TCS. Drives Around Block to test ABS, no avail, can't stomp on break hard enough to lock wheels cause traction too good.
Today Part 4: Confused and Drives 20 Miles (ABS and TCS light turns off when stopped and on when moving but turns off randomly) #ABS sensor Problem probably
Today Part 4 cont: Restart engine and TCS + ABS is GONE!! #YAY
Today Part 4 cont: But Brake + Battery Light Turns ON #QWE@#%#%#A
Today Part 8: Posting this on forum to see if ne1 else knows wtf is going on. I swear my car is out to f*$% me.
Day 0: SES light comes on, I get code p1320 and misfire in cylinder 6. Tested resistance of coil: 3.3M ohms #Bad
I order new coil.
Day 1: SLIP and TCSOFF lights come on, some occasional shaking. #EXPECTED
Day 3: ABS Light turns constant #WTF Never Seen This Before, stops driving car and wait for coil
Today part 1: Coil Arrives/Installed, Reset OBD, ABS + TCS Still On #ERR
Today part 2: Disconnect Batt and ABS TCS SES SLIP All ON #!!!!
Today part 2 cont: OBD 1320 No Cylinder Misfire Code #???
Today Part 3: Reset OBD, ABS and TCS. Drives Around Block to test ABS, no avail, can't stomp on break hard enough to lock wheels cause traction too good.
Today Part 4: Confused and Drives 20 Miles (ABS and TCS light turns off when stopped and on when moving but turns off randomly) #ABS sensor Problem probably
Today Part 4 cont: Restart engine and TCS + ABS is GONE!! #YAY
Today Part 4 cont: But Brake + Battery Light Turns ON #QWE@#%#%#A
Today Part 8: Posting this on forum to see if ne1 else knows wtf is going on. I swear my car is out to f*$% me.
#2896
It now sounds like an alternator problem to me....http://forums.maxima.org/showthread.php?t=535158
#2898
oh i also want to lower my 02 but i only wanted to do the front since it is much higher than the rear, can anyone advise good or bad? or how much is a good drop (") thanks for the anticipated help
#2899
Noticed this morning while warming the car up, my A&B trip miles were reset to 0.0 mi. I know it was at about 530 mi prior as I was keeping count of how many miles after I changed my IACV. Clock, and radio presets were normal. Any ideas what the hell happened?
#2900
Originally Posted by majesticmaxima
oh i also want to lower my 02 but i only wanted to do the front since it is much higher than the rear, can anyone advise good or bad? or how much is a good drop (") thanks for the anticipated help
#2901
Is it a good idea to pay $400 to get the 90,000 mile scheduled service done to my car at All Tune & Lube??? Cause it seems a bit much to me; they are only changing the oil, oil filter, air filter, spark plugs, and drain and fill the radiator. The rest i think they are inspecting, well the guy there said that he was going to do the BG44k thing to my car thru the brake booster hose (i already did the seafoam thing to the gas tank and the engine crankcase) so is this amount too much or can i do it on my own?
#2902
Originally Posted by sirjinx21jay
they are only changing the oil, oil filter, air filter, spark plugs, and drain and fill the radiator.....can i do it on my own?
#2903
Guest
Posts: n/a
i have a nooooobie question: the insulation on the hood, is it for sound or heat? ive wanted to remove it for a long time for weight reasons but im afraid the hood could get warped from the heat. i felt it one time and there was a considerable difference in temp between the temp on the surface of the insulation and the surface of the inner hood. any thoughts?
#2906
Originally Posted by DasYears
i have a nooooobie question: the insulation on the hood, is it for sound or heat? ive wanted to remove it for a long time for weight reasons but im afraid the hood could get warped from the heat. i felt it one time and there was a considerable difference in temp between the temp on the surface of the insulation and the surface of the inner hood. any thoughts?
#2907
Guest
Posts: n/a
Originally Posted by soonerfan
you realize you could get the same weight reduction by removing a can of coke from the cup holder?
#2914
hey everyone
newbie here with a 2002 maxima
i just bought it and it came with an aftermarket head unit which didnt work so i got another one but unlike the non working unit, the pins in the back are different
the new one has 8 pins lined up in a row while the old HU had 4 on top and 2 on bottom setup
can anyone please help
also, my foglights do not light up
the car is a 2002 GLE
appreciate it
newbie here with a 2002 maxima
i just bought it and it came with an aftermarket head unit which didnt work so i got another one but unlike the non working unit, the pins in the back are different
the new one has 8 pins lined up in a row while the old HU had 4 on top and 2 on bottom setup
can anyone please help
also, my foglights do not light up
the car is a 2002 GLE
appreciate it
#2915
Guest
Posts: n/a
Originally Posted by SlurpeeKing
hey everyone
newbie here with a 2002 maxima
i just bought it and it came with an aftermarket head unit which didnt work so i got another one but unlike the non working unit, the pins in the back are different
the new one has 8 pins lined up in a row while the old HU had 4 on top and 2 on bottom setup
can anyone please help
also, my foglights do not light up
the car is a 2002 GLE
appreciate it
newbie here with a 2002 maxima
i just bought it and it came with an aftermarket head unit which didnt work so i got another one but unlike the non working unit, the pins in the back are different
the new one has 8 pins lined up in a row while the old HU had 4 on top and 2 on bottom setup
can anyone please help
also, my foglights do not light up
the car is a 2002 GLE
appreciate it
You have to get a wire harness kit for your radio.
Check your fuse and relay for the fogs and replace them.
The relay is located in the relay box that is on the passenger side engine bay next to your coolant res. It is the back right one, also labeled on the relay box cover.
#2916
Originally Posted by TurtleHead
You have to get a wire harness kit for your radio.
Check your fuse and relay for the fogs and replace them.
The relay is located in the relay box that is on the passenger side engine bay next to your coolant res. It is the back right one, also labeled on the relay box cover.
Check your fuse and relay for the fogs and replace them.
The relay is located in the relay box that is on the passenger side engine bay next to your coolant res. It is the back right one, also labeled on the relay box cover.
and where is the fuse for the fogs?
mine didnt come with a manual
#2918
Originally Posted by SlurpeeKing
mine didnt come with a manual