Hard starting, extremely hard and black smoke
#43
First sorry, Im working I have no time to read your post, I hope it can help you, I really understand your feeling about this problem....
After doing everything on this board, my car did like your.
What I did (and it worked!!) : unbolt what you can of the tranny screws. Sand all the galvanized stuff on it. Try to sand the inner filet too.
Use diaelectric grease and put the srews back.
Hope its a new answer... lol . Cost nothing.
good luck
After doing everything on this board, my car did like your.
What I did (and it worked!!) : unbolt what you can of the tranny screws. Sand all the galvanized stuff on it. Try to sand the inner filet too.
Use diaelectric grease and put the srews back.
Hope its a new answer... lol . Cost nothing.
good luck
#44
i installed a grounding kit a couple of weeks ago so aswell as clean some of them, i doubt my grounds are the issue
im going to try another ignition switch and see if that solves anything tomorrow, i already have the dash pulled apart
im going to try another ignition switch and see if that solves anything tomorrow, i already have the dash pulled apart
#45
got another ignition switch installed it and no dice, any more suggestions, BTW im not throwing any codes, ive just about had enough, the car is getting ready to go to nissan to find out the problem but i would like to avoid their *** rapage for diagnosis.
#47
First sorry, Im working I have no time to read your post, I hope it can help you, I really understand your feeling about this problem....
After doing everything on this board, my car did like your.
What I did (and it worked!!) : unbolt what you can of the tranny screws. Sand all the galvanized stuff on it. Try to sand the inner filet too.
Use diaelectric grease and put the srews back.
Hope its a new answer... lol . Cost nothing.
good luck
After doing everything on this board, my car did like your.
What I did (and it worked!!) : unbolt what you can of the tranny screws. Sand all the galvanized stuff on it. Try to sand the inner filet too.
Use diaelectric grease and put the srews back.
Hope its a new answer... lol . Cost nothing.
good luck
#48
Check your camshaft sensor, one of the wires in mine was frozen and I had that starting issue where your car cranks, makes a small pause and then cranks again and starts. I replaced the sensor and the car works like a champ now.
#50
#52
Hmm... wow your car is still having problem? I remembered thinking, YES we have solved another problem, but I guess, not?
But from what you posted, your starter is still spinning even though you took the key out. Which means that somehow it is still getting power, that is not from the ignition switch.
I wish I could just drive over to your house and see this for myself because I am having a hard time visualizing all the little parts and stuff in our cars, but I think there was another member a while back who had the same mysterious issue, where the car would keep running after the key was out.
But from what you posted, your starter is still spinning even though you took the key out. Which means that somehow it is still getting power, that is not from the ignition switch.
I wish I could just drive over to your house and see this for myself because I am having a hard time visualizing all the little parts and stuff in our cars, but I think there was another member a while back who had the same mysterious issue, where the car would keep running after the key was out.
Thread
Thread Starter
Forum
Replies
Last Post
MaximaDrvr
7th Generation Maxima (2009-2015)
16
08-19-2015 08:20 PM