- Motor Mounts Bad?
- Driving after restoring headlights
- Blower Motor Won't Turn Off
- Passenger side wheel bearing..whos done it?
- ecu harness/acess removal ?
- Sigh, Velocity Stack Round 2
- Exhaust help needed
- car has a little vibration when idling
- 99 Injen CAI on an 02 SE?
- Velocity Stack, Filter Required?
- Maxima HID Retrofit Build
- Heater acting funny: A little Pre-Diagnosis Discussion
- Transmission Diagnosis/Advice
- 3.5 intake installed and battery relocated - Idle problem
- Lower oil pan replacement, follow instructions on RTV Grey package?
- heated steering wheel wiring (plug)
- Stealing input and amp turn on from bose sub connector ??
- Pre-cat rattle, clip inside, opinions?
- v35 steering wheel?
- How much is a front lip for a SE 20th anniversary?
- Test Pipe Q's
- Fuel Running Rich????
- KYB Price check...
- Please help! Bucking while driving!
- Found My Next Car
- Opinions on eBay halogen hid bulbs
- Will 4th gen struts fit on a 5th gen?
- Auto Shifter Light
- Rust next to rear license plate lamp
- Nwp spacers + oem gaskets?
- Transmission Install Advice
- vibrating clutch fork?
- Alignment necessary after strut mount replacement
- new car!
- Power window, slow roll up ....
- 2002 maxima exhaust
- Need some advice car pulling right?
- Sway Bar Comparison
- SES #3 misfire and now a bad knock
- BOTH FRONT LOWER CONTROL ARMS
- voltage issue
- weird noise in reverse?
- Look at what I just got!
- Cattman Performance - Major Changes!
- How often do you pop your hood?
- o2 sel issue on 2002 5.5
- car hesitates
- 2.5" or 3", Please step in
- Tein H Techs or Megan Racing Springs?
- RPM guage out and starting issues....
- Mileage Computer Light Fix
- interior lights dim
- Harbor Freight Fuel Pressure Tester
- Engine replacement or odometer rollback??
- low fuel light bulb size and part number?
- 2000 SE 5 Speed Flywheel
- Sporatic clutch problem
- TC tensioner or pre cats?
- 2002 MAXIMA INSTALLED A TRANSMISSION COOLER
- what is the size of the wedge base of the cluster bulbs?
- Problem with MOOG sway bar endlinks
- Help "Nissan Immobilizer System of NAS?
- Obx Headers Out of Production?
- not again...damn you pothole
- Suspension Part ID?
- help me with these codes please!!!
- Snapped Power Steering Pressure Sensor
- Motor Compatability
- POWER DRIVER SEAT MOVES WHEN IT WANTS TO
- WTF is causing this vibration??!!
- Anyone with an active Carfax (or similar) account?
- sun roof not working:(
- Anybody know Mike Crombie in Canada?
- 2k proper TPS adjustment?
- Alaska Road Trip
- Planning to replace my clutch tomorrow...
- couple of quick questions...
- P0304 code. Does my spark plug look alright?
- Trouble removing idler pulley
- Umnitza angel eye question
- BC or D2 coilovers??Which one??
- Custom so called ice box short-ram INTAKE
- **BLACKKILA.GTR MAXIMA**
- Gab mod, and wont idle?
- 4 codes and a slight engine knock only at idle.
- HELP Car is Making an ODD noise!!!
- bigger maf question
- New brakes. Squeal/grind noise
- Cluster Issues
- Photos: C-mod Nissan Maxima 02-03 Mesh Grill
- Changing catalytic converter with CA Spec Cattman Y Pipe
- all weather floor mats
- Installed OBX Headers now I got a problem need help
- Fog Light Rewire Problems "HELP"
- Ebay find stillen kit
- New Alternator, Blinking Battery Light on Dash
- Dead Radiator
- stock hids
- ***Serious Problem *******
- rad n tranny problems
- Inner Tie Rods
- WTF!!!! Weak as* fork broke!!!! (pic inside)
- R and R'ing my motor
- LED light strips on my maxima (pics inside)
- Rear Brake Caliper rattle
- 5.5 front brake pads from Nissan, still depositing?
- What do you expect to have if you've got bad TB on a 5.5 gen ?
- Can anyone with a VIAS block plate explain to me the benefits?
- need to replace this bulb...
- Need Motor mounts???
- Radiator Leak
- TRAILER HITCH INSTALLED ON 2002 MAXIMA
- kinda simple safc 2 tuning ?
- Fed cat in a CA spec car?
- 5.5 gen throttle body cleaning
- only one speaker working...Non bose, 03 se.
- Clutch squeal/squeak
- Which CPS?
- Which O2 sensor to buy for Bank 1 Sensor 1 replacement?
- Hmm thinking about cutting the cats this week..
- Cattman 3 in
- 6th gen plastics in a 5.5
- want to replace the motor mounts...03 SE AT..
- Screwed up with one of the front cross member bolts... what to do?
- gauge cluster not workin!!! lil hesitation..
- Stock exhaust
- Repoed
- p0456 after BOP Install. Coincidence?
- Anyone broke their glove box...?
- Maxima Retrofit!!
- 03 Maxima Cabin Filter
- Service engine light
- muffler
- Exhaust problems
- needing some insight
- Wet in all the wrong places...
- Let's be analytical - horsepower loss and long intake...
- 4th gen in a 5th gen
- clear coat repair
- strange problem
- SSIM How To?
- Cant align motor mounts!
- If you've changed your cats or gutted them, step in
- Which Coilovers would you Buy?
- Bank 2 Sensor 2 Oxygen Sensor confusion...
- Berk Intake install problem
- Coil pack problems again????? Need advice
- SCRATCH REPAIR
- How do you launch your car?
- Start up engine tick tick noise
- Start up engine tick tick noise
- Procedure for removing rear caliper brake lines
- Clear cover insert for turn signal ?
- clutch pedal sinking
- INSTALLED NEW FOGLIGHTS & FOGLIGHT FILM & WINDOW TINT
- AC Tranny issue
- Having trouble with folding LED mirrors
- A blower motor upgrade?
- Bose Subwoofer wire codes
- Battery issue
- stumped by an electrical issue, please help??
- Throttle Position Sensor
- speed sensor?
- Custom intake
- Damn flood...need help
- obx header installed
- LED conversion complete..but light still comes on...why ?
- Header owners please chime in
- Just installed some new tweeters
- Need help locating EGR componets on a 01
- VIAS Solenoid Help
- Clutch condition with pics
- Smaller battery.
- Check Engine Light Replacement
- 03 power windows switches needed
- tach needle lag
- 6 speed transmission makes a clunking noise when letting off the gas
- qiuck question about motor mount
- Injen COLD air intake - modification
- cosmetic damage to wood trim shifter handle.
- Haltech Platinum Pro 350z PnP on 5.5Gen
- Vibration noise when holding on da brakes in Drive
- Noise at thottle body
- Northern owners chime in please!
- HELP!! Cracked Wheel/Rim
- Cruise won't set
- SES codes?
- About to order O2 bungs. What type?
- Low idle cold start
- Broken Battery ground on block
- That vibrating license plate...
- headlights
- The inconsiderates got me
- 7th Gen Engine Cover In a 5.5?
- 6spd swappers please step in.
- Autotrust Struts?
- Vacuum Line
- Scratched _ Rotors _
- Airbag compatibility, what will work for an 01?
- VQ35DE still amazes me!
- gap between the headlight and the bumper
- Need help: revving on own while stopped
- Feels lumpy at low RPMs
- Odd idle issue... 2003 VQ35
- Warpspeed Y & cat ('00 CA Spec); mating to Megan 2.5 dual-outlet catback
- Where to fabricate an input device on a 5th gen (pics inside)
- Help! Broken Spark Plug :(
- flywheel torque specs
- Rear brake noise
- My Maxident
- 036mtmax's progress thread
- Changing Belts...Change Idler Pulley As Well?
- maxima hit
- Best replacement HID bulb/temp for car ?
- Bringing my AE back
- Main cat good or bad?
- Help ... Help ... parking brake cable
- Labor quote (hours) for '00 Y-pipe replacement and AC fan resistor replacement?
- Rear Brake Caliper
- So suddeenly the car began to fart really loud...
- Berk doesn't make parts for Maxima anymore?
- How to Paintless Dent Removal Technique
- energy suspension control arm bushing
- evap purge valve code...replaced valve code still pops up?
- I put a cheap plastic AutoZone scoop on my 2001 Maxima!
- No spark, won't start. Why?
- B-Pipe install gasket
- 5.5gen 6 speed...I didn't like redline 75w85 gear oil , back to Amsoil or what ?
- Spoiler light
- Header question
- Wanna See How Dirty a "Lifetime" Fuel Filter Gets?
- My Maxima = PMS machine
- No signal at ignition coil
- Thumping on startup
- What The Squeak!
- at home paint job
- Leather Seat Swap (Heated)
- Hesitation/Jerking at slow speed
- How much does the upper intake manifold weigh?
- Greddy EVO 2 cat back on 5.5 gen?
- Fog light fuse keeps blowing! HELP!!!
- condensation in light
- What brand of HID Foglights?
- Floor Pan Sheet Metal Gauge
- part replacement
- Some smoke in back of engine bay
- Motor Mounts
- Me Again, now I have a crunchy sound, LOL
- I'm tired of the CEL, now I'll take it to a Nissan dealer
- headers install?